top of page


DENAFRIPS all-new USB DAC solution comes with full licensed Thesycon Driver. The following guide & screenshots are self-explanatory.

Step 1: Download and install Thesycon USB Driver for Windows. Installation guide attached

Step 2: Connect the standard USB cable from PC USB port to the DAC USB input.  

Step 3: Plug in the Power Cord to the DAC, turn on the power. The DAC Standby LED should light up. It's tiny piece of pinhole size indication LED in red, cool, isn't it?

Step 4: Press the Power Button once, the DAC shall turn on. Select USB input. The USB input LED should light up. 

Step 5: Check the DENAFRIPS USB Audio Device Control Panel, DENAFRIPS DAC should be detected as "USB HiRes Audio"

Thesycon Control Panel.jpg

Step 6: DAC Info and ASIO Buffer Size setting. You may set the ASIO Buffer Size to increase/reduce the latency. It depends very much on the computer processing power. The higher the processing power, the lower buffer size you can set.

Buffer Setting.jpg


We recommend roon / JRiver for Windows OS. You may use other software to playback the music, the key point is to configure the software to use the DENAFRIPS USB DAC in 'Exclusive Mode' so that it bypass the Windows OS Sound Mixer settings.

JRIVER Basic Setup

Step 1: Launch the JRiver app. Go to 'Tools'->'Options'

Jriver Option.jpg

Step 2: Select "Vinshine DENAFRIPS USB DAC [ASIO]" in Audio Device setting

Jriver Audio Setting.jpg

Step 3: Enable Bitstreaming: DSD. This setting allow JRiver to play DSD files with DENAFRIPS USB DAC via ASIO Driver

Bitstream DSD.jpg

Step 4: Audio Device Setting of the DENAFRIPS ASIO USB DAC

ASIO Setting.jpg

Step 5: It's done. Play some music & enjoy!

PCM Playback.jpg


*For other playback software, the steps to set up are similar. 

bottom of page